MICA BAND HEATER
Reheatek mica band heaters are constructed by winding a nickel-chrome resistance ribbon around mica insulation and encapsulated in a stainless steel sheath. With temperature capabilities of up to 480°C, these heaters are ideal for plastic processing applications and for anywhere heat is needed on a round or curved surface.
CERAMIC BAND HEATER
Ceramic band heaters are designed with spirally wound inner resistance coils evenly threaded through interlocking insulated ceramic "tiles". The ceramic core of tiles is housed beneath a stainless steel sheet with serrated edges. Typical applications are plastic molding, extrusion and molding presses.
NON-STANDARD LOCATION OF LEADS OR TERMINALS
Terminations could be offset, paralleled, centered, or at each end. Lead wires are available.
Leads or terminals may be located at any reasonable place along the heater for applications where standard connections may be inaccessible.
HOLES AND CUTOUTS
Mounting holes locations could be customized. Please provide drawing for hole dimensions and locations.
ONE PIECE OR TWO PIECE CONSTRUCTION
2 Piece construction is very suitable for locations where 1 piece is difficult to be installed.
2 Piece construction is available with any termination or clamping styles.
BUILT-IN STRAP OR SEPARATE STRAP
Built-in strap and separate strap both provide secure and strong clamping.
Built-in strap - the top sheet is made into a strap by placing barrel nut fasteners on either side of the gap.
Separate strap - it's recommended wherever possible. Typically used in smaller diameters.
BENT-UP FLANGE
It's for narrower designs, available with any termination style. It's the most economical clamping mechanism.
HINGES
It's designed for two-section heater band for applications where heaters cannot be slid over.
